Fittings & Measuring

Start by opening sliding door and feed screen between the strut and the hinge.

Then walk the rest round the front of the -  van you can open the drivers door and stand on the step to pull round and feed through the strut then the hinge.

Once both sides are covered, stand on the rear bumper and pull the ends in with the adjustable bungee. It needs to be taught but not tight - and that's it!

To take it off, just undo the bungee and from driver's or passenger side, open the door, stand on step and gently pull till free. Shake off any exess water, roll up and put in water proof bag ,then push as much air out as possible. Can be stored under roof space or RnR bed.

The screen will dry its self out if this process is done correctly.

Go to Shop